Products / TPMS

TPMS installations by machine type

Every machine loads its tyres differently, so the receiver count, repeater plan and sensor type change with the machine. Pick the machine and you get the layout we actually use.

Reach stackers

Container yard workhorses: compact layout, one receiver.

Container handlers and stackers

Short wheelbase, constant reversing, salt air.

RTG and RMG cranes

Long radio path from the wheels to the cab; repeater planning decides.

Straddle carriers

Wheels far apart, so the repeater sits between them.

Empty container handlers

Same salt air as a reach stacker, shorter wheelbase.

City and public-transport buses

One bus, few wheels, but a fleet needs the data centrally.

Mining trucks and heavy mining equipment

Highest loads and the hottest running tyres we serve.

Beam carriers and girder transporters

Dozens of axles: the radio plan matters more than the sensor count.

Mobile and all-terrain cranes

Road travel plus lift cycles, with the tyres loaded unevenly.

Telehandlers

Load shifts forward as the boom extends, so tyre pressure changes with the job.

Port AGVs

No driver: the alarm has to reach the fleet controller, not a cab display.

Aircraft tugs

Low-speed, high-torque duty where a soft tyre is a schedule risk.

Forklifts

Hard tyres, tight aisles; pressure still decides whether the truck tracks straight.

XCMG port machinery — supplied under their brand

Builder-specific record: our sensors and receivers go onto XCMG port machinery under XCMG's own label, with their part number, connector and protocol map.

What stays the same on every machine

0-1400 kPa gauge (100-1500 kPa absolute) at ±7 kPa, pressure and temperature per wheel position, 433.92 MHz with a 500 ms period, CAN 2.0B at 250 kbps by default (11-bit or 29-bit frames per unit), 9-30V supply, and IP68 on sensor, receiver and repeater. Up to 256 wheel positions per receiver is a specification, not a claim about any one machine.

What changes

The receiver count and the repeater count. On a reach stacker the receiver usually sits in the cab and one is enough; on a beam carrier or an RTG the steel blocks the radio path, so repeaters are placed along the machine from the axle drawing.

FAQ

How do I know which layout my machine needs?
Send the machine type, the axle layout and where the data has to land (cab display, machine controller or platform). The layout follows from those three, not from a wheel count formula.
Do you publish how many machines you have instrumented?
No. We describe the machine types we have done and the layouts we use. Unit volumes and customer terms are commercial information.
Is the hardware the same across machine types?
The sensor and receiver platform is the same; the sensor type follows the rim, and the receiver count follows the radio path.

Tell us the application

Send the vehicle, wheel count and where the data must end up. We answer in writing.