Products / TPMS
TPMS for B-Trains and Multi-Trailer Combinations
Up to 65,535 trailers addressable by short ID, 10 second polling cycle, 433.42 MHz trailer link separate from 433.92 MHz wheel sensors.
The B-train is the configuration where a fixed TPMS stops working - hook up a different set of trailers and the old sensor list is wrong. Our display polls for trailers in range and lists the short IDs present, so the driver picks the trailer rather than re-pairing twelve sensors.
Trailer polling runs on 433.42 MHz and wheel sensors run on 433.92 MHz. Two separate frequencies, so the trailer link and the sensor traffic do not collide.
One boundary worth stating: the trailer node is powered from the trailer supply and carries no SIM card. We do not read the trailer EBS or brake status.
What you get
- Up to 65,535 trailers addressable by short ID
- 10 second polling cycle
- 433.42 MHz trailer link, 433.92 MHz wheel sensors
- Driver picks the trailer on the display, or the dispatcher assigns it from the platform
Semi trailer TPMS - the full solution page · TR-100R receiver specifications · Tell us how many trailers you swap between
FAQ
- How does the display know which trailer is hooked?
- By polling for short IDs in range every 10 seconds; the driver picks the trailer from the list, or dispatch assigns it from the platform.
- Are trailer ID and wheel sensor data on the same frequency?
- No: the trailer link runs on 433.42 MHz and the wheel sensors on 433.92 MHz.
- Does the trailer node read brake or EBS data?
- No. It carries tyre pressure and temperature only, and no SIM card.
Tell us the application
Send the vehicle, wheel count and where the data must end up. We answer in writing.