Products / TPMS

TPMS for SPMT: pressure on a machine that cannot pull over

An SPMT does not fail one tyre at a time. It fails a load: a module goes down on a wheel nobody can see, the platform tilts, and the move - a bridge section, a transformer, a module of a plant - is now a recovery operation instead of a transport job.

Why an SPMT is the hard case for tyre monitoring

A self-propelled modular transporter is a flat steel platform on hundreds of wheels, and every one of those wheels is carrying a share of a load that has no alternative route. The driver sits at one end with no mirror that shows the far axle group, and the ground crew is walking beside a machine that is already moving. When a tyre starts to go down, nothing about the machine tells the driver until the platform is already level-troubled.

The radio problem is the second half of it: 433.92 MHz does not pass through a loaded steel deck with impunity, and an SPMT is a forty-metre steel deck. A sensor inside the tyre is the only place it can be on this class of machine, and the receiver has to sit where the platform allows - usually one end - which leaves the far wheel groups outside its reach unless the layout is planned from the drawing.

What the system actually delivers

  • Up to 256 wheel positions per receiver; 224 wheel positions have been displayed on one screen in our own test, and a 160-wheel, 20-axle beam carrier is in service.
  • 0-1400 kPa gauge (100-1500 kPa absolute), accuracy ±7 kPa.
  • Internal sensors (strap or built-in valve), rated -40 to +125 °C, IP68.
  • Repeaters, not one receiver and a hope: the count and the positions are calculated from the axle drawing, and the receiver reports by group.
  • Output to your controller: CAN 2.0B (11-bit or 29-bit extended frames, J1939-format message sets deployed), RS485 with Modbus RTU, RS232, or PROFINET through a gateway.

What we need from you to plan it

  1. The axle and wheel-position layout of the module set you run.
  2. Where the receiver is allowed to be mounted, and where a repeater can be fixed.
  3. Where the data has to end up: the transporter's own controller, a cab display, or a site system.

Three answers, and the layout comes back calculated rather than estimated. On a machine where the load cannot be set down anywhere, that difference is the whole point.

Field references: a major Chinese construction machinery OEM (XCMG) and SANY equipment are in service with this platform; the 160-wheel beam carrier installation is documented on the beam carrier page. For the wider multi-axle story see multi-axle TPMS.

FAQ

How many wheel positions can one receiver handle on an SPMT?
Up to 256 positions. The layout still has to be calculated: on a forty-metre steel deck the far wheel groups are outside the receiver's reach unless repeaters are planned from the drawing.
External or internal sensors on a modular transporter?
Internal, on this class of machine - strap or built-in valve. External hardware does not survive the deck, and on an SPMT there is nowhere for it to go.
Can the data go to our own controller?
Yes: CAN 2.0B (11-bit or 29-bit extended frames), RS485 with Modbus RTU, RS232, or PROFINET through a gateway. The message layout is documented and aligned to your DBC or parameter set.

Tell us the application

Send the vehicle, wheel count and where the data must end up. We answer in writing.