Products / TPMS
TPMS on a 128-wheel trailer: it is a numbering problem before it is a radio problem
A 128-wheel trailer is not a hard machine to put sensors on. It is a hard machine to keep the wheel numbering straight on - because a modular trailer is rebuilt for every load, and the moment the position numbers move, the pressure list becomes a list of numbers nobody can act on.
The numbering comes first
On a modular trailer the axles are re-arranged between jobs, and the same wheel can end up in a different place in the combination. A pressure system that simply lists "sensor 37" is useless unless 37 can be mapped back to a wheel position the crew can find with a torch. So the deliverable is not just the sensors: it is the wheel-position table, agreed with the fleet before commissioning, and the rule for how positions are re-mapped when the trailer is reconfigured.
The radio comes second
128 positions is well inside what one receiver addresses - up to 256 positions - so capacity is not the constraint. The constraint is the chassis: a modular trailer is a long steel deck, and 433.92 MHz does not pass through a loaded deck with impunity. The receiver is mounted where the trailer allows it, the repeater positions are calculated from the axle drawing, and the receiver reports by group. That is why we do not sell "one receiver and a screen" on this class of machine.
What the system delivers
- Up to 256 wheel positions per receiver; 224 positions have been displayed on one screen in our test, and a 160-wheel, 20-axle beam carrier is in service.
- 0-1400 kPa gauge (100-1500 kPa absolute), accuracy ±7 kPa.
- Internal sensors rated -40 to +125 °C, IP68; external sensors are available for machines where the valve stem is accessible.
- CAN 2.0B (11-bit or 29-bit extended frames), RS485 with Modbus RTU, RS232, or PROFINET through a gateway.
How a 128-wheel job is planned
- Axle layout for the heaviest configuration you run, and the number of wheel positions.
- Where the receiver can sit, and which positions that leaves outside its reach.
- Where a repeater can be fixed so that it is both heard and survivable.
- The position-numbering rule for the reconfigurations you actually do.
For the scale-up story see multi-axle TPMS and the 224-wheel case on the mining truck page.
FAQ
- Can one receiver really cover 128 wheel positions?
- Capacity, yes - up to 256. The layout is still calculated: on a long steel deck the far groups need repeaters, which is why we plan from the axle drawing.
- What happens to the wheel numbering when the trailer is reconfigured?
- It is a rule, not an afterthought: the position table is agreed before commissioning, and the re-mapping rule for your configurations is part of the deliverable.
- Internal or external sensors on a modular trailer?
- Internal on this class of machine (strap or built-in valve). External sensors are for machines where the valve stem stays accessible.
Tell us the application
Send the vehicle, wheel count and where the data must end up. We answer in writing.