Produtos / TPMS

The heavy haulage TPMS solution for multi-axle transport

Heavy haulage moves the load nobody else can carry, on a chassis long enough to attenuate 433.92 MHz before the signal reaches the last axle. The tyre system therefore has one job: import every wheel position into one place, and warn before a tyre is soft enough to matter. This page is how we configure it.

FAQ

Can one receiver cover a 160-wheel heavy haulage combination?
Capacity, yes — up to 256 wheel positions. Radio, not always: the chassis length decides how many repeaters are needed, which is why we plan from the axle drawing rather than from the wheel count.
Do you fit external or internal sensors on heavy haulage?
Internal on this class — strap-mounted or built-in valve, IP68. External units are offered on other machine classes, but on construction and port sites they are exposed and do not survive long.
How does the data reach our control system?
The receiver outputs CAN 2.0B at 250 kbps with a 500 ms data period by default, and can also be supplied with RS485, RS232, Modbus RTU or PROFINET. Where the machine has no controller, the same data goes to a 7-inch cab display or to a 4G uplink.

Tell us the application

Send the vehicle, wheel count and where the data must end up. We answer in writing.